![]() IS there software that I can design in and cut without using two different software. ![]() I have wasted HOURS of my life trying to get this to work from deleting the software to re-installing and over, and over and over with no luck When I create in inkscape then export to signcut, signcut closes and I have to start up all over again. I have been on the phone with the the place I have purchased the cutter from to signcut and so far the whole experience is been a wast of time. Now I wanted to use the cutter with the Mac and now its a total nightmare. I parked the cutter after a cutting job for 3 years and since switch everything in my business to Mac which also work with no problems. The sales place set me up with signcut and inkscape which worked with no problems on PC.
0 Comments
Leave a Reply. |